ALL PRODUCT LIST:

It’s the first to research and development”up to down” swinging grinding. The finished drill is sharpest, and the most durable.

1. Hydraulic system the device in the front part will be resulted force to prevent work piece tilt. 2. Pressure Constant. Clamping force can presetti...

1. The length of vise body is very short, but the clamping range is very big. It works with every kind of milling machine, CNC machine center. 2. Pre...

1. Vise bed height-size and guide block side are all made with full control, can 2,3, or4 vises to perform a job at a time. 2. Vise slide-chunk can t...

1. Down thrust with “semi-sphere” to prevent work piece lift. 2. Vise slide-chunk can take out, Convenient to clean away chips and inside of vise.

1. Most suitable for vertical machine center, milling machine. 2. Pressure system for maximum clamping pressure with minimum force.

The vise is different from general vise use for miller. It can be adjusted the angle for processing requirement, and its vertical angle can be adjuste...

1. Super hi-clamping force, even the air source at low pressure 8kg/cm2 which can be achieved super hi clamping force 9000kgf, and the 0~9000kgf clamp...

For grinding HSS and carbide engraving cutter as well as single lip or multiplelip cutters of various shapes such as radiused cutters or negative tape...

1. Clamping Studs: (4 ea, 3/4/5/6/7/8 inches or 75/100/125/150/175/200mm.) 2. T-Nuts 3. Flange Nuts 4. Coupling Nuts 5. Step Clamps 6. Step Bl...